DataCard RP90 Plus User's Guide download pdf (Page 70)

Laminator error recovery

64 RP90 Plus E and RL90 User Guide

Patch position

The position of the patch on the card can very slightly with a different lot of laminator

supply material. You can change the left-to-right position or the top to bottom position.

Change the left-to-right position

Use the laminator LCD panel to change the left-to-right position of the patch on the card.

See

“Using the Laminator LCD panel” on page 42 to use the Film Position setting.

Change the Top-to-Bottom Position

Move the supply-side sprocket once to shift the patch position, following these steps.

1 Power off the laminator and allow it to cool.

2 Open the laminator door and remove the

laminator cartridge.

3 Use the sprocket on the supply side of the

cartridge opening to change patch position.

4 Pull the sprocket out. It

moves a small amount.

5 Turn the sprocket knob to

move the patch:

— Turn clockwise 30° to

move the patch 1mm

toward the top of the

card.

— Turn counterclockwise

30° to move the patch

1mm toward the

bottom of the card.

— The sprocket does not

have a stop to indicate 30°; estimate the movement as closely as possible.

6 Release the sprocket.

Do not move the sprocket more than 30° from the default position.

7 Insert the cartridge, close the door, and power on the laminator. Press the Reset

button to initialize the supply material.

8 Laminate a card to verify the new position.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 88 89

No comments

DataCard RP90 Plus User's Guide Page 70