DataCard RP90 Plus Installation Manual download pdf (Page 10)

RP90 Plus Card Printer Installation Manual 7

Connecting the Power Cord(s)

1. Check the plug. The power cords vary according to model and country of

purchase.

2. Plug the power cable into the back of the printer.

3. If you use the optional RL90 laminator, plug the power cable into the back of

the laminator.

4. Plug the power cord(s) into the facility power source.

Warning: Always use a grounded power outlet that is not shared with other

electrical equipment.

Caution: Use an Automatic Voltage Regulator (AVR) if there is a possibility

of voltage fluctuations. Use an uninterruptible power source rather than an

AVR if there is a possibility of frequent power loss.

Caution: Do not power on the printer until instructed to do so during the

installation of the printer driver.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

No comments

DataCard RP90 Plus Installation Manual Page 10