DataCard SP75 Plus Installation Guide download pdf (Page 64)

Page 59

IS-01206 No Card Picked

A card was not picked successfully.

Possible Cause 1: The input hopper is empty.

Solution 1: Fan the edges of the cards so the printer picks one card at a

time and then load cards in the input hopper. Push the input hopper cover

closed until it latches.

Possible Cause 2: One or two cards are jammed going into the printer.

Solution 2 a: Release the stuck card(s). Fan the cards in the input hopper

again to separate them.

Solution 2 b: Cleaning liquid is making cards slip on the pick roller. Wait one

or two minutes with the input hopper open to allow the pick roller to dry.

If the problem occurs again, run a cleaning card, change the cleaning

sleeve, and then clean the rollers in the printer.

No comments

DataCard SP75 Plus Installation Guide Page 64